Movere can use a custom rescan file to target a specific segment of devices. Any custom rescan file must be in .csv format and contain two columns:
- devicename
- Domain
The devicename column is the value Movere uses to target the endpoint. This could be shortname, longname or IP address.
The Domain column simply tells Movere which credentials to use.
If scanning Workgroup, then simply open the Movere Console on a domain joined device, enter the Workgroup admin account you want to use, then in the rescan file enter the name(s) of the device(s) you want to scan, but put the domain name you entered the Workgroup credentials into as the domain being rescanned. Movere will target the Workgroup based device using the admin account assigned to the specified domain.
If running the rescan from the console, save the custom rescan file as a .csv or .txt file in the root folder of the Movere Console:
If running the rescan from a command line, place the .csv or .txt file into the DevicesToRescan folder:
Note: there must not be any carriage returns after the final entry in a rescan file. If Movere throws an error message when attempting the rescan file, confirm that the format described above is followed and there are no carriage returns at the end of the file.
Comments
0 comments
Please sign in to leave a comment.